Replacing the factory lenses with 3.0 inch Galaxy G5 bi-xenon lenses in Mazda 3

Mazda

The cost of work in each case is individual and depends on the condition of the vehicle optics, its malfunctions, the exchange rate when purchasing consumables and elements of vehicle optics and vehicle lighting.

Cost of works and materials:

Установчий комплект білінз 3.0 дюйма
3300 UAH
Шліфування та полірування фар
600 UAH
Обклеювання поліуретановою плівкою
850 UAH
Робота зі встановлення
2000 UAH

Mazda 3 після встановлення біксенонових лінз Galaxy G5, вигляд спереду

Overview

The car's headlights were very cloudy and scratched, which reduced the luminous flux on the roadway. When the headlights are switched on, the defect in the factory protective layer is very visible, small and deep scratches on the headlight glass are visible, the initial stage of the cloudiness of the protective layer of varnish.
The headlight glass was subjected to a full cycle of grinding and polishing, followed by a polyurethane film. The polyurethane film on the car's headlights adds gloss to the optics and also protects them from chemical and physical influences.
The factory halogen mono lenses were replaced with Galaxy G5 3.0-inch bi-xenon lenses for H1 lamps with 55w ignition units. The factory mono lens for the H7 halogen lamp already had carbon deposits on the reflective part of the lens due to the previously installed xenon in the halogen lens. (Do not install xenon lamps in halogen lenses!) The headlight glass was also washed inside from dirt, dust and foreign elements. A new sealant has been applied to the headlamp gutter to ensure maximum tightness of the headlamp and glass units.
A comparative luminous flux test before replacing the factory lenses and after replacing them with bi-xenon lenses showed good light and shadow contrast on the road surface. After replacing the lenses with bi-xenon, the car headlights did not change their design or appearance, and also received 4 high beams and excellent low beams!
The cost of the work performed:
More information
Car
Mazda 3
Completed works
- Установчий комплект білінз 3.0 дюйма
  3300 UAH
- Шліфування та полірування фар
  600 UAH
- Обклеювання поліуретановою плівкою
  850 UAH
- Робота зі встановлення
  2000 UAH
- The total cost
  6750 UAH
Result

The cost of the work in each case is individual and depends on the condition of the automotive optics, its problems, the exchange rate when purchasing consumables and installation elements for automotive optics and auto lights.

More completed works

Installation of bi-lenses in the headlights of the Toyota Prado 120

The headlights of the Toyota Prado 120 practically disappeared, as the halogen bulbs did not provide sufficient visibility.
Read more Встановлення лінз у фари автомобіля
Repair of rear lights on a Volkswagen Passat CC

Restoration of a rear light on a Volkswagen Passat CC with a crack and signs of wear.
Read more Ремонт Led оптики автомобіля
Polishing Mercedes-Benz E320 headlights

Restoring headlight transparency through grinding and polishing
Read more Полірування та шліфування автомобільних фар
Installation of bi-xenon lenses in Nissan Teana headlights

We upgraded the headlights of a Nissan Teana: installed bi-xenon lenses for bright light at night.
Read more Встановлення лінз у фари автомобіля
Unsuccessful replacement of bulbs with LEDs caused damage to the Mazda 6 optics

What happened after replacing the bulbs in a Mazda 6 — and why you shouldn’t do it yourself.
Read more Профілактика фар автомобіля у Києві