BMW
7-series e38The cost of work in each case is individual and depends on the condition of the vehicle optics, its malfunctions, the exchange rate when purchasing consumables and elements of vehicle optics and vehicle lighting.
Cost of works and materials:
-
Installation work
2000 UAH -
Set of 3.0-inch lenses
1700 UAH -
Connection work
350 UAH -
Soldering of headlight glass
450 UAH -
Headlight polishing
500 UAH -
Covering headlights with polyurethane film
800 UAH
-
Overview
Initially, the owner of this car wanted to seal the headlights. But he also understood that the lenses of his iron horse were no longer working at 100%. When dismantling the car, the owner asked to diagnose the factory lenses and, if necessary, replace the factory lenses in the car headlights.
-
When the headlights were disassembled, the car's lenses were carefully diagnosed for damage to the lens reflector. To get the most out of the light on the road, the factory lenses in the car's headlights needed to be replaced.
-
We replaced the standard lenses with Galaxy Q5 3.0 inch bi-xenon lenses. The bi-xenon lenses installed in the car headlights are 2.5 times more efficient than the factory mono lenses. The installed bi-xenon lenses provide not only effective low beam, but also additional high beam on the road surface. At the time of installation, we found some issues with the headlight seals, and the headlight glass was broken. Probably from a minor accident or some kind of impact to the headlight. The headlight glass was soldered, treated with a special chemical adhesive, and cleaned of dirt. The car headlights underwent a full cycle of grinding and polishing, followed by covering with polyurethane film to protect against stones, sand and chemicals found on the road.
-
Before/After
The car owner recently replaced the D2S Orsam bulbs, leaving the same bulbs in place. The difference in the car's lighting can be seen in the photos.
-
Cost of work performed:
More informationCar
BMW 7-series e38Completed works
-
Installation work
2000 UAH -
Set of 3.0-inch lenses
1700 UAH -
Connection work
350 UAH -
Soldering of headlight glass
450 UAH -
Headlight polishing
500 UAH -
Covering headlights with polyurethane film
800 UAH -
The total cost
5800 UAH
Result
The cost of work in each case is individual and depends on the condition of the car optics, its problems, the exchange rate at the time of purchase of consumables and installation elements of car optics and auto lighting.
-
More completed works
-
Repair of rear lights on an Infiniti FX35
The owner of an Infiniti FX35 was left without clearance lights and brake lights due to burnt-out diodes. We re-soldered the line with new original diodes and restored the rear lights to their factory condition.
Read more Prevention of car headlights -
Replacement of standard halogen lenses in KIA Carens optics with quattro xenon
Complete light upgrade for frequent highway driving: halogen lenses were replaced with bi-xenon lenses and quattro light was connected for maximum effect.
Read more Встановлення лінз у фари автомобіля -
Replacement of standard lenses in BMW 1-series e87 headlights
Complete diagnostics and repair of headlights after damage: replacement of lenses, ignition units, grinding, protective film and electrical work. The light is renewed, the headlights are like new — ready for the road.
Read more Installation of lenses in car headlights -
Sealing the headlights of a Lexus RX 400h
We fixed the consequences of poor-quality repairs: removed silicone, applied new sealant, polished the headlights and protected them with film.
Read more Герметизація автомобільних фар -
Installation of Galaxy Q5 3.0 inch bi-xenon lenses in Peugeot 605
Comprehensive headlight upgrade: clear glass, Galaxy Q5 3.0‘ and Morimoto Mini H1 2.5’ bi-xenon lenses, black matte reflectors and company logo on the lenses
Read more Installation of lenses in car headlights
We value your privacy 
